FITTING and CARE INSTRUCTIONS

Signature Mouthguard Type 3 ProPlusGel

To help you get the best from your Signature mouthguard, please follow these easy directions.

Note: DO NOT USE WITH ORTHODONTIC BANDS

Fitting Instructions (read thoroughly FIRST before implementing)

Please note that Adults must supervise the fitting of this mouthguard.
Do not place this mouthguard in a microwave oven.

If you are experiencing discomfort or pain in your mouth, contact your dentist before fitting.

1. Place the mouthguard over the upper teeth to test for size.
2. If too long or uncomfortable, carefully trim with scissors to fit, following the trim lines.
3. Practise pressing the mouthguard firmly to the roof of the mouth with tongue, whilst biting gently on the mouthguard.
4. Place the mouthguard into near boiling water for 15 seconds. DO NOT HEAT ANY OTHER WAY. Remove with a fork and shake water off.
5. Once cool to touch insert mouthguard into mouth and bite firmly to obtain an even bite impression. Do not bite through the mouthguard.
6. While the mouthguard is in position, suck the guard into place by exerting pressure with the tongue against the roof of the mouth.
7. Using your fingers, mould the mouthguard around the side of the teeth.
8. Finally, remove the mouthguard and immerse in cold water.
9. Thoroughly dry the mouthguard.
10. Carefully open the sachet labelled "PRIMER". Pour contents into mouthguard and spread evenly with your finger. Gently shake off any excess and dry your finger.
11. Obtain a flat, flexible mixing utensil (e.g. paddle pop stick or blunt knife).
12. Carefully open sachets labelled "Part A" & "Part B" onto a flat clean surface (e.g. a plate) and keep them separate.
13. Thoroughly mix "Part A" & "Part B" together for 15 seconds.
14. Place ALL the mixed GEL evenly into the SENIOR mouthguard.

14a. Use ONLY Two Thirds of mixed GEL for JUNIOR mouthguards

15. Place mouthguard into your mouth and bite firmly but not hard. Keep this position for 4 minutes.
16. Gently take the mouthguard out of your mouth with two hands and rinse for 30 seconds under lukewarm water.
17. Trim off any excess GEL with scissors. (DO NOT PULL OFF EXCESS GEL)
18. For your protection the GEL does not glue/stick to the mouthguard shell.

 

Care Instructions

1. To maintain normal hygiene, you should rinse the mouthguard in cold soapy water after each use.
2. Store mouthguard in the box supplied.
3. Do not use solvents to clean.
4. Do not place in boiling water or leave on parcel shelf of car.
5. Your mouthguard is made for you, do not let others use it.
6. Your mouthguard has been designed for one season's use. For optimum benefit you should replace your mouthguard every season.

WARNING

Signature mouthguards cannot stop accidents or damage being done to your mouth. They can, however, lessen damage and in many cases protect you from serious damage to your teeth.

We strongly advise that you take every possible precaution in all your activities including wearing protective clothing and headgear and observing recommended safety guidelines issued by sporting bodies etc.

The Signature New Generation Mouthguard is available in Junior and Senior Sizes:

Signature Mouthguard Type 1 – Suitable for contact sports at a lower level. Suitable for use with most orthodontic bands.




Signature Mouthguard Type 2 - Suitable for contact sports at a medium level. Impact strip increases lower jaw protection.




Signature Mouthguard Type 3 – Suitable for all sports to a professional level. Unique Gel sets to provide custom fit. NOT suitable for use with orthodontic bands.




Signature Mouthguard Type 4 – PROFESSIONALLY PRESCRIBED CUSTOM MOUTHGUARD